下面这个ANSYS命令为啥最后不能生成轴力图弯矩图之类的答:我把你的命令流稍微调整一下,中间有些改动,你看看!/PREP7 ET,1,LINK1 R,1,0.01 R,2,0.005 R,3,0.0125 MP,EX,1,2.1E11 MP,PRXY,1,0.3 n,1 n,2,6 n,3,12 n,4,18 n,5,24 n,6,6,8 n,7,12,8 n,8,18,8 TYPE,1 MAT,1 REAL,1 E,1,2 E,2,3 E,3,4 ...
ansys beam 188 弯矩图 咋画呀,救救我吧,大侠答:你这应该是只输出了i节点,没输出j节点。给你个命令,需要哪个轴弯矩就用哪个。ETABLE,Mx_I188,SMISC, 4 ETABLE,Mx_J188,SMISC, 17 ! x轴弯矩 PLLS, Mx_I188, MX_J188 ETABLE,My_I188,SMISC, 2 ETABLE,My_J188,SMISC, 15 ! Y轴弯矩 PLLS, My_I188, My_J188 ETABLE,Mz_...
ANSYS 结构分析中单元beam44和beam188不能输出梁的弯矩图?答:可以输出,给你发个例子吧 FINISH /CLEAR /FILNAME, EX /UNITS,CGS /TITLE,EX.txt, SIMULATION OF OVER-DETERMINED BEAM WITH MORE NODES /PREP7 N,1,0,0 N,2,0.06,0 $ N,3,0.12,0 $ N,4,0.18,0 N,5,0.24,0 $ N,6,0.30,0 $ N,7,0.36,0 N,8,0.42,0 $ N,9...